Mirmanto, ST., MT., PhD.

Nama : Mirmanto ST., M.T., Ph.D.
NIP : 19700312199803 1 002
Jabatan Struktural : Kepala Laboratorium Fenomena Dasar Mesin
Email : mirmanto@unram.ac.id
Pendidikan S1 : Bachelor in Engineering, Department of Mechanical Engineering, Gadjah Mada  University, Yogyakarta, Indonesia
Pendidikan S2 : Master in Engineering, Energy Conversion, Department of Mechanical Engineering, Gadjah Mada University, Yogyakarta, Indonesia.
Pendidikan S3 : PhD in Fluids Engineering, Division of Mechanical, Faculty of Engineering, Brunnel University, Uxbridge, Middlesex, United Kingdom.


Flooding and flow reversal in a vertical pipe with elbow and bell-mouth outlet system.
Jurnal Media Teknik, UGM, 2000.
The effect of the pipe length toward flooding in a vertical pipe with sharp inlet-sharp outlet,
Jurnal Oryza Universitas Mataram, Juli 2001.
An experimental of solar water purification with and without commercial mirror reflector.
Oryza, Vo. II/No. 4, ISSN No. 0125-169X, Januari 2004
The performance of solar air heater using zing absorber and the air flowing below the absorber.
Oryza, Vo. III/No. 4, ISSN No. 0125-169X, Januari 2005
The effect of catalyst and methanol mixer toward flash point and gross heating value of castor oil.
Jurnal Termodinamika dan fluida, BPPT BTMP, Balai Termodinamika Motor dn Propulsi, No. 15/Tahun VIII Volume 1, ISSN: 1410-2757, Juni 2004.
Mechanic properties and micro structure of EMS 45 welding with V and X joint model.
Oryza, Vol I /No. 4, Januari 2003 ISSN:0125-169X.
An experimental solar water heater with and without commercial mirror reflector.
Oryza, Vol II/No. 4, Januari 2004. ISSN:0125-169X.
The effect of the reflector angle to the performance of solar water heater bare tube type.
Oryza, Vol IV/No.2, Juli 2005.
Thermodynamic review of rubbish energy in Mataram
Oryza, Vol. IV/No.3, Oktober 2005.
Characteristic of water flow in PVC pipe, pipe joint and gate valve.
ORYZA, Vol. 6/No.3 Juli 2007.
Calorimetric value of organic rubbish.
Jurnal Teknik, REKAYASA, Vol. 7/No. 1, Juni 2006.
Pressure drop and heat transfer characteristics for single-phase developing flow of water in rectangular microchannels
Conference, Eurotherm 12, Poitiers, France.
Flow patterns and heat transfer measurements for flow boiling of water in a rectangular microchannel.
Conference, Micro fluidics 2012, Heidelberg, Germany, 2 – 3 September 2013
Flow boiling of water in three different hydraulic diameter rectangular microchannels
Imperial College London
Pressure drop and heat transfer characteristics for single-phase developing flow of water in rectangular microchannels, Journal of Physics: conference series.
Journal of Physics: conference series, 2012
Developing flow pressure drop and friction factor of water in copper microchannels, Journal of mechanics engineering and automation.
Journal of mechanics engineering and automation, 2013
Prediction and measurement of pressure drops of water flowing in a rectangular microchannel,
Jurnal Dinamika Teknik Mesin, 2013
Heat transfer coefficient calculated using a linear pressure gradient assumption and measurement for flow boiling in microchannels,
Int. J. Heat and Mass Transfer, Elsevier, Vol. 79, 2014.
Effects of boiling in the upstream loop on instability of flow boiling in a microchannel
Jurnal Rekayasa, volume 14 no. 12, 2013.
Effect of tube diameter and surface roughness on fluid flow friction factor
dinamika teknik mesin volume 4, no. 2, 2014